The CHS-790 operation table is for operating on patients with serious problems at hospitals and clinics. For the comfort of the patients and efficient operations by the doctors, it offers various position adjusting functions. Its safe, rigid design will prevent any mechanical part from breaking down during an operation.

Operations

• Up/Down Adjusting
  1.Up : Fling open the pump pedal and keep pressing the foot pump pedals. The table will be lifted by hydraulic pressure.
  2.Down : Press the pump pedals to the floor, below the lower deactivation limit. The table will slowly go down.
• Right-Left Tilting
  Push in and turn clockwise the right handle and the table will be tilted to the left (max. 20°). Turning the handle counterclockwise will tilt the table to the right (max. 20°).
• Front /Rear Tilting
  Pull out and turn clockwise the right handle and the head section of the table will go downward (max. 25°). Turning the handle counterclockwise will lower the plate.
• Back Section Angle Control
  Pull out and turn clockwise the left handle and the back section will rise (max. 80°). Turning the handle counterclockwise will lower the back section until the table is horizontal.
• Head Section Angle Control
  Pull out the knob at the bottom of the head section and then, with the knob pulled out, adjust the tilt of the head section.
  Then, loosen the knob (up: 15° and down: 90°). The lowered head section can be lifted up by hand.
• Leg Section Tilt Control
  Pull out the knob at the bottom of the leg section and then, with the knob pulled out, adjust the tilt of the leg section.
  Then, loosen the knob (up: 15° and down: 90°). The lowered leg section can be lifted up by hand.
• Kidney Tilt Control
  Push in and turn clockwise the left handle and the joint between the hip section and the back section will be bent (max 115°). Turning the handle counterclockwise will array the table horizontally.

Features

• The table is consisted of head rest, back section, seat, and bifureated legs.
• The table is equipped with a head-end control device for positioning by turning the handles located under headend.
• Stickers showing how to operate handles are placed on the handle housings.
• The table is mounted on iron based covered with stainless steel and the table top is covered with bakelite.
• The table-top is rotating 360 degrees.
• The table base is mounted on 3 caster wheels enabling it to be moved to any desired place.
  lt also has a braking pedal.
• The table can be lifted up and down 75cm to 100cm by pressing the hydrauilic pedal.
• 40mm thick sponge rubber mattress is covered with vinyl for easy cleaning.

Dimensions

Accessories