Simple and Robust

Zero air loss enables quick payback on investment. As a small size of use, it can also be applied to the field pipe lines and others. Test Key is built in, so you can check the operation at any time.

Durable

The internal diameter of the seal discharge is 7∅, so the small size pipe scale or foreign material is easily discharged. Life of Diaphragm verified 1 million times based on cold tap water. Once installed, it can be used for as long as a compressor.

Specification

There are two types of materials available : up to 60°C for NBR (oil injected) or at slightly higher temperatures for VITON (oil free).

If the diaphragm is damaged due to foreign material in the pipe, the air is continuously leaking into the discharge port. The right to use Pre-filter(strainer) as a solution to a problem.

Generally one million performance tests have been validated in clean and cold water environments.

Installation for Dryer and After-cooler

When installing at the after-cooler and dryer it may be necessary to install the equivalent tube but this can be difficult due to the construction of the on-site. In this case, you need to install a [Air Vent(speed controller)] to open the air very thoroughly to remove the air pocket to make the trap work. However, the air opening is very mild, but you must check the air when checking in the field. If the [Air Vent] is blocked, the trap will not work. These installations are equally applicable when the eqivalent pressures(balance tube) in the reservoir are severe. (Air Vent sold separately)